Repair kit fits these multi-pump guns made after 1995 & they have a compression tube that slides out of the assembly & does not need a special tool (has a cartridge valve & the valve is NOT soldered). It may be necessary to push out the assembly from the front of the tube: Benjamin 397 & 392 guns as well as Sheridan C9 (Silver Streak) & CB9 (Blue Streak). To determine if this kit is for you:

• Remove the screw in front of triggerguard to remove rear part of the stock
• Remove the pins or screws that hold the retention cap at the rear of the receiver
• Remove the guide pin, spring & hammer to reveal the compression tube
• If the brass compression tube comes out in one piece, then this is the kit you need
• If your gun has a rounded square hole with a valve stem sticking up through it, then you need the other repair kit (CR/Repairkit)